I wanted to design a new 4010 blower fan model (seperate from my remixed model) for my BIQU H2.

I uploaded two other model variations set back 1mm & 2mm, just in case your head needs more clearance for a silicon sock or if you feel the blower end is too close.

Print in PETG, ABS or any heat resistant filament.

Please use a high RPM 4010 blower fan for maximum airflow.

No 4010 blower fan mounting screws required. When you press in the fan, the little extruded tabs should grip the screw holes.

Enjoy!

Rate/Post Your Make/Offer Suggestions