All in one calibration test
Copyright Claim
All in one calibration test
Boost
47
81
13
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
47
81
13
0
241
75
Released
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 30% infill
Did exactly what it was intended to do. This print was super helpful identifying my printers strengths, weaknesses, and fine tuning some of my settings.
1
Reply
May I ask how you printed the lollipop and what material you used? I'm experiencing an issue where my long rod gets skewed by the nozzle at higher layers, resulting in a shape that is indescribable.The material I am using is PETG.
请问你的棒棒糖是怎么打印的，是什么材料？我的长杆在高层会被喷头带歪导致打印的难以名状。我用的PETG
(Edited)1
Reply
Replying to @user_1331145095
The print shown in the picture was printed in eSUN PLA+. I don’t have much experience with filaments that aren’t PLA/PLA+, so I’m not sure I’m able to offer many pointers but all of the settings I used were exactly what’s given in the print profile, I didn’t change anything.
I hope this helps, and good luck!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
great tester
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld