58mm Spin Ring with Finger Loop for Umikot (58mm) Espresso WDT Tool Remixed by will.floor

Remixed by

will.floor

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 20% infill

Designer

51 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

A simple remix of the top spin ring for the Umikot WDT tool that adds a finger loop for smoother, faster operation. I've found this method to be much easier to use than either the upper handle or handle-less options.

Comment & Rating (6)

@le_jims

Printed to replace the top from the 58mm Umikot. Unfortunately it did not fit, it's too tight to fit. Used the default settings so not sure if they need further adjustments

The designer has replied

@will.flaugher

Thanks for the feedback. It might be a tolerance issue with your printer as I've made several that fit without issue. Perhaps you can tweak your flow/extrusion settings or do outer/inner wall order in the slicer?

@le_jims

Replying to @will.flaugher :

Thanks for the reply. I noticed that I used default Umikot print settings when I printed that model, and the default settings for your remix are a bit different to that - namely - the top shell layers for Umikot vs Remix respectively: Top Shell: 4 layers vs 5; Bottom shell layers 4 vs 3, Sparse infill density 15 vs 20, infill combination unchecked vs checked, brim object gap 0.1 vs 0.8mm. Would these settings need to be equal? One other thing I notice that the Umikot has a long 'needle' which protrudes from the top spin ring which is missing from your model. Was there a reason you omitted this from your remix? Cheers

(Edited)

@will.flaugher

Replying to @le_jims :

Strange - I don't see that "needle" on the umikot either on makerworld or printables. Are you working off of a remix? Maybe that explains some of the differences?