Lens cap (M43/MFT)
Remixed by
Copyright Claim
Lens cap (M43/MFT)
Remixed by
Boost
0
0
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1 h
1 plate
Open in Bambu Studio
Boost
0
0
1
0
12
5
Released
Description
Summary
M43/MFT lens cap
There are 3 versions, v1 is the same as v2 only on the v2 isn't a groove on the top so it will look better after print. V3 is different, it was supposed to look like Cars Zeiss rear lens cap cine.
Better to print from PETG than PLA
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:part doesn't fit (too small)
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld