The Devil's Daughters - Asian Red and Black Ink Art of A Deadly Demon Woman Pt1 - Wall art
The Devil's Daughters - Asian Red and Black Ink Art of A Deadly Demon Woman Pt1 - Wall art
Boost
2
4
3
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
6 h
1 plate
Open in Bambu Studio
Boost
2
4
3
0
10
4
Released
Description
The Devil's Daughters - Asian Red and Black Ink Art of A Deadly Demon Woman Pt1 - Wall art
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Red
At layer #14 (1.2mm) swap to Gray
At layer #18 (1.52mm) swap to Jade White for the rest.
Comment & Rating (3)
All
Print Profile
0.08mm layer, 2 walls, 100% infill
Absolutely gorgeous print. Thank you!
0
Reply
Hi, I'm a big fan of your work.
If I can make a suggestion though, try to arrange the models on the left side of the bed, and if you use a prime tower, it should get on the right side.
The reason I ask this is because more often than not, the PTFE tube hits the sidewall of the machine (P1S) if the printed model is close to the right edge.
Thanks in advance and keep up the good work!
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld