Lily Pod - Small GoPro tripod by Kondzio29

Kondzio29

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.2 h

1 plate

4.8(10)

Open in Bambu Studio

Boost

Released

Description

Take you GoPro on the adventure and bring a Lily Pod along!

Tripod screw base: HERE

Lily Pod is tripod inspired by nature - by Lily petals unfolding. This tripod can be assembled without additional hardware - just with a piece of filament and some glue! Only hardware needed is for the GoPro mount with simple M5 nut and bolt.

You need to print base, three legs and three hinges.

Assembly as follows:

Glue the hinges to the legs as you can see in the photo using your glue of choice (I used CA glue)
After glue is dried place the leg in the base and thread a piece of filament through the hole in the base and the hinge.
Make sure the filament is inserted all the way.
Using side cutters vut the excess of the filament from the base.
Put a drop of glue on the filament end to secure it.
Repeat steps 2-5 for the other legs.
Insert M5 nut in the place (of the fit is too tight you can heat the nut)
Done!

Comment & Rating (20)

@3DGearSolution

Boosted

Is truly brilliant. Is small, compact, handy and incredibly brilliant! i'm really excited about this project and even more so by the ingenious twist on using the filament to lock the arms! keep up the good work! Happy printing!

The designer has replied

@Kondzio29

Thank you for the boost and kind words!

@DarkEnergyLab

Print Profile

0.2mm layer, 2 walls, 15% infill

Excellent model!!! Good Print and fantastic design… Thanks so much!!!

The designer has replied

@Kondzio29

Nice filament color!

@gilmbento

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice design, printed flawlessly

The designer has replied

@Kondzio29

Nice! great print!

@Keppo87

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

bellissimo e molto utile finalmente un treppiedi piccolo e non ingombrante!! utilissimo per la mia gear360

@3DGearSolution

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

@THEAYPISAMFPV

Print Profile

0.2mm layer, 2 walls, 15% infill

The designer has replied

@Kondzio29

thanks for the rating! Would you mind sharing what was the problem with the profile so I can improve it?

(Edited)

@THEAYPISAMFPV

Replying to @Kondzio29 :

yeah, I don't have glue so a version where the hinges have an interference fit with legs would be awesome (and sufficient, the glue isn't necessary for that application). just make the tolerance 0.1 between the hinges outer walls and the legs inner walls and that should do it !

(Edited)