Works with:
Maxtrax board from daver18qc.
Note: The board is 1/8 (not 1/10 as described), don't resize it!
Mount it on the:
- roof rack with 4mm diameter (print part A+B)
- sideways on the car body just drill the holes on the body of the car (print part A only)
4x M2x6 screws needed.
Print Parameters:
- Resolution: 0.15
- Infill: 100%
- Perimeters: 3-4
- Rafts: No
- Supports: No
- Material: PETG/PLA/Any
- Sequential printing reccomended