*** WIP *** Installation manual is still in progress ***

This is a replica of the original front plate for the Fractal Design Terra PC Case. I ordered it because the dark wood doesn't quite match the table. It can of course also be used if the original plate is broken.

Printable of course in any color to match your setup perfectly.

The replacement is very easy, only 5 screws have to be loosened to remove the front panel as a whole and then another 6 small screws that hold the actual front panel in place.

I have always printed the model on my Bambulab X1C on the front itself, so you can achieve a nice texture. For this you can use the PEI Plate to achieve nice structures or the Engineering Plate to achieve a nice smooth surface.

Supports are not needed. It uses around 25g of Filament and took 46mins on my X1C.

My recommendation for printing:

print it on the front side so you wont need supports

0.2mm layer height
0.42mm line width
25% infill
no supports

no raft
brim not needed but maybe you could choose mouse ear (in OrcaSlicer)
wall count doesnt matter