GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
6
4
4
0
17
12
Released
Description
Quick to print and easy to assemble phone stand! Keep as a backup or take one travelling.
To assemble first separate the three pieces. The middle size foot fits into a slot in the larger backrest and then the small locking pin fits into foot.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
great !!!
0
Reply
The print was successful using POLYMAKER Polyterra PLA. However, it is too flexible to hold my Samsung Galaxy Ultra 23 in its case. What did I do wrong?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice Profile printed without problems.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld