Inner frame replacement for Radon Cable Guide Rear Derailleur Swoop 170 / Jealous AL found on Cube mountainbikes. This because the nut gets ripped out of the original clip if your (front) shifter shifts heavily.

Needed: 

• 1x The 3D print
• 1x M3x5.7 mm Threaded insert
• 1x Original outer-cap
• 1x Countersunk M3x20 (or longer)
• Soldering iron to melt the threaded insert in the 3D print

Recommendations:

• Print at high infill
• Print with small layer hight
• Print with many outer walls
• Print in ABS or ASA