My Signum Rack was sitting too close to my desk to fit my power strip, so I designed two 25mm spacers to push it down. The spacers are designed to fit two M8 Bolts. I printed mine using Fuzzy Skins because I was experimenting with them, but I personally wouldn't bother using Fuzzy Skins. The model should be printed in the same orientation it comes at, with the flared out part on the build plate. However, when mounted to the Signum Rack, the print should be flipped over, as the flared out piece was designed to match the flare on the mounts that Ikea provides. I printed these at 20% infill, but using 10 or 15% would probably work just as well.



To do this, you will need:

-Two of these parts

-Two 30mm M8 Bolts

-Two M8 Washers