Ground stake with hook
Ground stake with hook
Boost
9
19
11
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
29 min
1 plate
Boost
9
19
11
0
32
57
Released
Description
This is my take on a simple stake for securing things into the ground. It has a small hook and a hole to accomodate the user. There is a small flat area on the top of the stake to allow the user to hammer (carefully) the stake into the ground.
The stake has some texture to give it some purchase in the ground. Personally, I used this stake to pin the bottom edge of some chicken wire to the ground.
This stake uses roughly 10 grams of ASA printed solid. You should use a few wall loops at least for strength.
Comment & Rating (11)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
works on. may break as it ushers thin.
The designer has replied
0
Reply
hello, thank you for your comment. Where did it break?
0
Reply
Replying to @dpile103
Hi, one of it breaked at the head when trying to push it into the earth ground. Perhaps that could be bigger. I used the recommended walls in your print profile. The others I printed worked fine. Perhaps it was too much pressure from my side.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
just what the wife wanted
The designer has replied
0
Reply
Glad to hear it. Thank you for the message.
0
Reply
Made one off your post in thangs website and they work perfect for staking in the mount on a starlink base if your leaving it on the ground outside!
The designer has replied
0
Reply
That is great to hear! Thank you for your comment.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld