A keychain design of the packaging for my Sloffies(slides or flip-flops).

A while back, I shared the design of my Sloffies. I had such an overwhelming positive response from the 3D printing community that, as a small thank you, I designed the packaging into a keychain. It prints without supports.

sloffies_packaging_keychain_top Print Settings

Wall Line Count - 3
Top Layers - 4
Bottom Layers - 4
Infill Density - 15%

sloffies_packaging_keychain_bottom Print Settings

Wall Line Count - 3
Top Layers - 4
Bottom Layers - 4
Infill Density - 15%

sloffies_packaging_keychain_insert Print Settings

Layer Height - 0.15
Wall Line Count - 0
Top Layer - 2
Bottom Layers - 2
Infill Density - 30%
Infill Pattern - Gyroid
Combing - Off

Thank you for supporting my design. I really appreciate it.