This is a complete re-design of a lithophane holder I saw earlier on Youtube or here on Thingiverse. But this was for a small lithophane only and I needed a bigger one. Since nobody was able to share the design files with me so I could change the dimensions and add improvements, I decided to design my own. And here it is....
Lithophane settings using LithoPhaneMaker.com (100% square image is essential!)
Frame Option: Framed
Lithophane Resolution: 0.3
Lithophane Height: 150
Angle: 90
Frame Width: 5
Frame Height: 5
Overhang Angle: 45
Maximum Thickness: 3.6
Minimum Thickness: 0.6
Picture Spacing: 10
Preferred PLA: eSun PLA+ Cool White.
Printer settings for best results: Layer Height: 0.1mm, Speed: 45-60 mm/s, 6 walls, 99% infill (not 100%).
Electronics needed: standard 12V stuff you can get from Banggood, Wish, Aliexpress, Amazon, etc.
Shopping list (please CHECK if you have the right one/size as they change quite often):
Use these (use 2 pcs): https://www.wish.com/product/5c07382dbf1d21419b669b96?share=web
Or these (use 1 pc): https://www.wish.com/product/5c7f6c46e279f231e0ccd3c3?share=web
Lid attachment: any M4 nut and bolt will do.