Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
7.3 h
2 plates
Boost
23
31
5
0
54
30
Released
Description
Simpel lamp. Just add a E14 cord set from the bottom and screw everything togheter.
The base might need som extra bottomlayers so the light doesn't shine thru, depending on what color you use.
In the picture I have used Sunlu Marble and white PLA.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
Nice design
The designer has replied
1
Reply
Thank you! 😊
(Edited)1
Reply
Have had this printed for some time now. Thanks for sharing when i asked for this in a FB 3d print group.
The designer has replied
1
Reply
Thanks for sharing 😊
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Nice
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld