Underdesk Drawer with Hexagonic Design
Copyright Claim
Underdesk Drawer with Hexagonic Design
Boost
2
4
3
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
6.5 h
2 plates
Open in Bambu Studio
Boost
2
4
3
0
9
0
Released
Description
An under-desk drawer with a rail that can be mounted under your desk with screws or adhesives.
There are 6 holes with a diameter of 5 mm on the rail part for screws, or you can use adhesives if you prefer.
The drawer body may need some supports, organic supports served me well!
Comment & Rating (3)
All
Print Profile
0.2mm layer, 3 walls, 30% infill
Other Issues:to cold and dirty plate
The designer has replied
0
Reply
that's your filament setting not the print profile
0
Reply
yes, I testing a new filament addnorth e-pla and I have done wrong setup so I will try again 🙂 Thanks 👍
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld