Honda LightBox by LusoPrint3D

LusoPrint3D

Art>Signs & Logos

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 15% infill

Designer

5.9 h

2 plates

5.0(2)

Open in Bambu Studio

Boost

Released

Description

This is a simple Honda logo lightbox. I didn't add any hole for the cable, because the placement preference may be different from person to person.

You can make a hole by adding a negative part, like a cylinder, and putting the negative part in the desired place, then use the mesh boolean option.

The parts I used were bought at aliexpress and you can check them in the list below:

LED controller: https://shorturl.at/kCUVX (choose USB only)
LED Strip: https://shorturl.at/pEY06 (choose 1m 60 IP30)

If you have any suggestions or want any tips, feel free to leave a comment or send a message.

Comment & Rating (4)

@badbrain3000

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

Printed well but small filament from black went into the white. Will try again but maybe slower to prvent it. You can see it on the top right part Edit : printed again and no issue, so probably my bed was dirty

(Edited)

The designer has replied

@Lusoprint3D

I can see that. But it's odd since the color white is the first color to print at each layer. Or did it stain above the 1st layer of white and can be seen throught it? That can be caused by the nozzle oozing. It could be because of the temperature, the retractions, or even humidity in the filament. Also, different filament brands need different parameters.

(Edited)