Donnager Class from the Expanse by martin.taichl

martin.taichl

Hobby & DIY>Vehicles

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 2 walls, 15% infill

92.6 h

11 plates

4.5(2)

0.16mm layer, 2 walls, 15% infill

88.9 h

7 plates

5.0(1)

Open in Bambu Studio

Boost

108

150

Released

Description

This is my MCRN Donnager class model from the show the Expanse. Model is some 35cm long and comes with a stand. It is a kit so it does not require a single drop of glue to put together.
I highly recommend to use the following video in order to assemble it

Comment & Rating (4)

@RockieOnly1

Print Profile

0.16mm layer, 2 walls, 15% infill

for this profile, most of these prints came out great, with the one exception being the plate with the railguns which peeled off every time no matter what I did. these really need brims to hold them down as they have such a small narrow contact area on a long and narrow part which causes it to warp. also, on the plate with the pegs, there isn’t enough pegs, it’s 4 pegs short for all the peg holes this model has, and a couple to few extra would be nice in case you drop or lose one.

(Edited)

The designer has replied

@jnangano

The guns should be printed with supports, I'll modify the parameters on that. I did enable the supports on those when I printed it, but it was set to global so I cleared it. As for the connectors I will review the parts and add any if necessary.

(Edited)