Sauna Rain Scoop

Sauna Rain Scoop

Boost
4
3
2

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

ABS, 0.15mm layer, 6 walls, 25% infill
ABS, 0.15mm layer, 6 walls, 25% infill
Designer
2.5 h
1 plate

Boost
4
3
2
1
7
6
Released

Description

With this rain scoop, you can evenly distribute the water over your sauna stones and generate a nice, controlled burst of steam!

It's designed to fit to a standard 24mm broom stick; if you want, you can secure it with a small screw.

 

I recommend printing it in ABS because of the temperature. PLA somewhat also works, but you can feel that it starts to get soft in the sauna or if your water is quite warm.

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Very nice, thanks for providing the design! Just printed it with translucent purple PETG, let's see how it is going to hold up to the heat in the sauna. Will post an Update once I got a chance to test it. Print itself went fine, but I am having a bit of trouble removing all the supports, but that is not too important, the water won't care I guess :D
The designer has replied
0
Reply
Thanks for the feedback. I think PETG will do the job - my first version was in PLA and only got soft if you left it in the hot water for too long. Besides from that, even PLA worked fine and I just replaced it with ABS because I revised the design a bit (first version didn't have the internal divider wall). If you have trouble with removing the supports, you could try printing it with PLA as support interface layer - then support removal will be very easy.
0
Reply
No more