Stand for Laptop in vertical position
Boost
4
13
6
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
4.6 h
2 plates
Open in Bambu Studio
Boost
4
13
6
1
39
19
Released
Description
Laptop stand to use them ass aditional screen in work.
You don't have to use any other material - just print and click
3:30 hours to print, Preffered PLA/PETG
Comment & Rating (6)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
Two of the four X-bracket legs do not fit properly in the main body, I had to chip away some PLA in order for the parts to fit, I also used superglue just to be safe. So there is room for improvement, I’m overall very happy with the result though!
Besides that the stand is rigid and fits my Dell Latitude laptop perfectly.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
This has been a really useful print. No problems with it.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Other Issues:had to trim the X brace connector ends to fit the uprights, and almost to much of an angle for my laptop (screen doesn’t fold back far enough) but overall it printed nicely on my p1s with pla and serves its purpose
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld