Based on Ryan's design.

Remixed to utilizes an enclosure based design to secure the patch antennas instead of double sided tape.

Does require foam mounting tape (only one side is needed) in order for antenna not to scratch surface of goggles. Refer to attached images for proper mounting of foam tape.

Print with antenna pass-through hole facing down as it will enable the other end to be bridged. Refer to attached PrusaSlicer image for orientation.

Made for:
TrueRC X-Air MK II
https://www.truerc.ca/shop/5-8ghz-2/receiver-long-range/x-air-5-8-mk-ii-pair-for-hdzero-vrx4