I remixed several low poly pokemon designs and turned them into wall hooks. My son was always throwing the towel onto the ground in his bathroom so Lapras has been saving the day for the last year or so. Finally decide to add some other pokemon as well and share them for other pokemon fans. The clip prints super fast and screws into the wall. Any of the pokemon can slide onto the clip with easy. If the fit is tight or too loose then I recommend increasing or decreasing the size of the wall piece by 1%. It's designed not to be too snug so that the can come off easily if you want but tight enough that they shouldn't move at all with daily use.
If you are printing this to hang heavier objects on I would definitely bump up the infill. It's currently at 15% and I have not done any weight testing with increased infill as I've only used these for towels and hats. If anyone bumps up the infill and does weight testing definitely leave a comment letting me know how it goes.
Shout out to the original designers of each pokemon! Happy printing.