Lidl Glider Pusher Power Pod
Designed for 12 x 12 mm M2 hole mount.
I used a Racerstar Racing Edition 1806 motor with a 4" prop.
Designed to be printed with no supports. To make it stronger, print at a higher temperature.
V2 is for motors shaft that stick out past the motor base.
For the 12 x 16 mm mount
https://www.thingiverse.com/thing:5585789
For the 16 x 19 mm mount
https://www.thingiverse.com/thing:5624386
My set-up
3S 1000mah lipo
3 x 5 gram servos
3 bladed 4 inch prop
Racerstar Racing Edition 1806 75 watts at full power
25a ESC
All up, weight 320g
Flight video https://youtu.be/dKA-KWGKGeA
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
orange
Notes:
Printed at 215 degrees