This is a simple wall mounted holder for the release key used with Eufy smart doorbells such as the E340.

Fit to the wall either with a standard screw, or with double sided adhesive tape and keep your release key in a convenient location.

Printing Instructions

In my profile I have it standing on the small end. It prints absolutely fine this way providing you have good bed adhesion. If you have bad bed adhesion then you can add a brim or try printing it upside down.

Print Settings

• Layer Height: My profile is set to 0.16mm for the sake of the curved base, but any layer height will work and be functional.
• Infill: 10% gyroid is more than enough
• Walls: 2
• Material: PLA