I have designed a simple case for NFC tags. The plan was to make clones of my children's Tonies, as the originals take up too much space when travelling. A magnet can be placed in the centre so that the tags stick to the Toniebox (and other tags).
The model is designed for 10x3mm magnets and the inner diameter is 39mm. If this does not suit you: I have attached a parameterised Fusion 360 file, where all relevant dimensions (incl. tolerance) can be freely set. However, you should bear in mind that the NFC tags need a certain distance (at least 4mm) from the Toniebox in order to be recognised reliably.
If you are not familiar with Fusion 360, you can also leave a comment with the desired dimensions and I will upload an appropriate model.
Recommendations:
Comment & Rating (46)