Dinosaur Lightbox with Your Name
Dinosaur Lightbox with Your Name
Boost
52
77
21
Print Profile(2)
4 colors version
Designer
3.2 h
2 plates
5 colors version
Designer
3.3 h
2 plates
Open in Bambu Studio
Boost
52
77
21
8
115
73
Released
Description
Dinosaur Lightbox with Name, Size: 17*17*3 cm. It has 2 holes at the back for hanging on the wall. I suggest using 5v led.
The bottom file has pre-cut hole for led power wire in different sizes, both on the back and on the side.
How to “create” the hole for the USB cable
Before printing, open the desired hole deleting the correct object in the side panel:
How to change the text
⚠️ ATTENTION ⚠️
Before printing, remember to face down the object (reverse printing) and check for correct text slicing .
Before printing, slice and check! If on the first layer there is only the text it means that you did something wrong (i.e.: you skipped the step at second 38 of my YouTube guide).
Lightbox Desk Stand
If you want to hang the lightbox on your desk or shelf, try my Lightbox Desk Stand, available in 3 different size:
Commercial license
Do you want to sell prints of this model? You can purchase commercial licensing for this model by joining the Commercial License in my Patreon.
Comment & Rating (21)
All
Please help. I follow your video directions perfectly; however, I get a floating regions error whenever I slice. I don't understand what I am doing wrong. I have printed many light boxes like this without issue.
The designer has replied
0
Reply
mmm very strange! can u send me the 3mf via private message? thanks you
0
Reply
I had the same thing happen to me. I think it's the text height (the name). I changed the text height like it showed on the YouTube short BUT the Z height was 0.60 for me. I'm not sure if that will be the same for you but mess with that number until the error goes away and it's basically flush.
0
Reply
That is amazing! I loved the way to change the name!! Great job!!!
The designer has replied
1
Reply
😊
0
Reply
Hey there .. can you explain how I can do the reverse printing? please. thank you
The designer has replied
0
Reply
hi! simply "face down" the object, so the part with your custom text will be in direct contact with the printing plate!
0
Reply
Replying to @ValeriaMomo
Thank you ... I will try.
0
Reply
Print Profile
4 colors version
originally had first layer adhesion problems. creator contacted me and it was entirely my fault for not moving the text to be flush when flipped to put the face down.
(Edited)The designer has replied
0
Reply
Hi Tyler, can you send me the print file you tried to print by message so I can check it? thanks you
0
Reply
Print Profile
4 colors version
Super cool print, nice feature with custom name
0
Reply
Boosted
Print Profile
4 colors version
The designer has replied
0
Reply
Thank you so much for your review, you encourage me to make new models! Thanks again. cheers, Valeria
0
Reply
Boosted
Print Profile
4 colors version
The designer has replied
0
Reply
thanks you :)
0
Reply
Boosted
Print Profile
4 colors version
0
Reply
Boosted
Print Profile
4 colors version
0
Reply
Boosted
Print Profile
4 colors version
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld