A mounting bracket for the FTTC Network Connection Device (NCD) that is used for connection to the NBN in Australia.
This is designed to mount against the wall and hide the power cable.
Printer Brand:
Raise3D
Printer:
N2
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.25
Filament:
3DFilles PETG
Notes:
Print with the 2 hole side facing the bed, this requires supports for the (4) mounting screw pads.
Printed using 5 walls (perimeters) and minimal infillYou will need M3 Tap and tap handle, Qty (2) M3 x 10mm long screws
Tap the 2 x Ø2.5mm holes to M3
In each tapped hole, install a 3mm x 10mm long button head, pan head or Countersunk screw and screw in until the screws hold the NCD securely. You could also use self-tapping screws.
The NCD has 2 x Keyhole slots on the rear for screws.
Secure the bracket to the wall using suitable fasteners for your application, I used 8Ga Pan head wood screws