Search models, users, collections, and posts
Hammer holder
Remixed by
IP Report
Print Profile(2)
0.24mm layer, 6 walls, 25% infill
12.5 h
3 plates
0.24mm layer, 6 walls, 15% infill
17 min
1 plate
Open in Bambu Studio
Boost
111
375
13
9
343
129
Released
Description
I love this take on a hammer holder. I found it was a bit small to hold some of the bigger hammers out there. I modified it where there was more meat holding it all together. I also redesigned the part where the hammer sits. It is now a gentle curve which should self center and wont turn one way or the other. The files I have are basically a single hammer holder, double, triple and quadruple. I cannot print a quad due to the size of my bambu bed. I plan to print two triple holders and line them up.
The designer did a great job! Kudos to him. Happy holdings!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (13)