7 Day Travel Pill Box by Kagman

Kagman

Tools>Medical Tools

GIF

Print Profile(8)

All

X1 Carbon

P1S

P1P

X1E

V2 NO RX Logo 0.2mm layer, 3 walls, 100% infill, support

Designer

1.8 h

1 plate

5.0(2)

V2 w/ RX Logo 0.2mm layer, 3 walls, 100% infill, support

Designer

1.9 h

1 plate

V2 NO LABELS 0.2mm layer, 3 walls, 100% infill

Designer

1.8 h

1 plate

V2 (SPANISH) 0.2mm layer, 3 walls, 100% infill

Designer

1.9 h

1 plate

Click to see more

Open in Bambu Studio

Boost

144

377

464

Released

Description

A simple TRAVEL pill box that fits in your pocket, purse, etc. You can also use it for regular pill storage.

VERSION 2 UPDATE (APRIL 2024)

V2 CHANGELOG

Created a new “Snap Together” design. It should work much better over the original version.
v2 design now loads pills from the side (v1 was from the top)
Added a finger inset making it easy to rotate to each pill day.
Added a sliding lock door to prevent the rotation and possibility of pills falling out in your pocket or elsewhere.
Days of the week are now shown on the bottom due to side rotation design.
Added Multiple Languages (dm me if you have a request)

Assembly

On a hard flat surface, using your hands, please press down hard the top model into the base model.

Recommended Print Settings

100% Infill
.4 nozzle
.2mm MAX layer height.
Add tree support (to support finger inset)

Depending on your filament, please supply adequate cooling for smooth print surfaces. Nozzle thickness and layer height also greatly improves the smoothness of spinning.

Comment & Rating (74)

@elauna

Print Profile

Supports, 0.2mm layer, 2 walls, 15% infill (Bottom), 100% infill (Lid)

work well although you have to unscrew the screw in order to move the top part and get the meds. with thinner walls it could be a bit smaller or hold more meds

The designer has replied

@brwyatt

I think you rated the wrong model and profile. This model doesn't have any screws and doesn't look anything like your picture.

@elauna

Replying to @brwyatt :

sorry. you are right. I also printed this model but was impossible to snap in both sides and I ended breaking the parts.

(Edited)

@brwyatt

Replying to @elauna :

No worries! Just figured it was worth mentioning so the right prints get the right reviews! And yeah, I also found similar with this model. This profile I uploaded does a bit better than the original (adding supports and a bit more strength to the clips), but only so much can be done without modifying the model itself. Looks like you found a much better variant overall in the end, though! (and I found a similar one that also seems to work better than this model)

@brwyatt

Print Profile

0.2mm layer, 2 walls, 15% infill

Definitely needs supports, but the profile lacks them. I'm slightly concerned that while it appears to work for now, that the middle part is significantly weaker as a result and will likely fail after some use. I'm going to retry with added supports and will upload that as a profile if it works alright.