8bitdo N64 Controller Buttons

Hello, this is my first ever 3d file submission! Hope you enjoy. Feedback welcome. Keep in mind, I'm an amateur at this.

I wanted colored n64 buttons for the 8bitdo N64 controller, so I made some. They aren't as smooth as resin printed. I guess I could have lacquered or epoxied the surface, but then the tolerances would be off.

The file is set up so all you need to do is load your AMS and click print. Each plate takes about 1hr to print. I could have fine tuned it more but this is a hobby, not a job. haha.

I used orca slicer, and haven't tried the Bambu profile yet. Sorry.

REQUIREMENTS: USE 0.2mm Nozzle

RECOMMENDATIONS: 

• PLA BASIC - Haven't tried anything else
• SMOOTH HIGH TEMP PLATE 
• FACE DOWN - tangs in the air. You will want a smooth surface against your thumbs, print it face down
• NO SUPPORTS - You will need to trim the tangs a teeny tiny bit of sagging material due to no supports, but it's quick and easy. The tangs are supposed to be 1.5mm tall, but has a little bit of room for error. This is important for proper silicone pad actuation.
• NO BRIMS - Wash your plate first. It'll stick if your bedplate is clean

DISCLAIMER: The “real life” model pics are all my test prints, I didn't feel like disassembling the controller for the final actual buttons that I used.