Stairway to heaven Challenge
Copyright Claim
Stairway to heaven Challenge
Boost
30
24
7
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
30
24
7
0
59
3
Released
Description
Here is another fun and challenging print.
Can you BEAT my stairs ?
This print will challenge your bed adhesion of your printer. I know what you think … “ nah eazy … lets do it ! ” but it is not that easy as you Think !
First run for mine x1c was 21 and half floor ! Cool plate + 3DLac
Rules of this one are simple :
- Dont use any brim / skirt / raft option
- Speed must be more or equal 60 mms
- use print profile included or do equivalent for your printer.
- use PLA
- glue/tape or other “helpers” are allowed but… chalenge it more with non.
- take picture of your failure or success in comment and enjoy others envy . ^^
Comment & Rating (7)
All
man that title pic is clickbait lol
9
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I would say 5 stars but i can't!
(To give a 4-5 star rating, at least one successful print record of this print profile is required.)
Nice challenge, 1st test 27th floor complete, then it falls and spaghetti detection paused the printer,
See my timelaps video link :
(Youtube)
https://youtu.be/4-pJ8w6bmsg
The designer has replied
0
Reply
nice ! you beat me :) but ! I will try another one ! :P
(Edited)1
Reply
Replying to @ThomasSitto
I had z-hop enabled, disabled it now, but still no 100%.. 😅
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
excellent
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
didn’t try the challenge just needed some basic stairs for a hedgehog
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:After 5 stair, felt off from the bed, I try clean my sheet and try again :)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld