If you like this print and would like to donate a boost, that would be much appreciated.

Made as a kit so as to get the best print quality. The 2 ends of the caliper and separator slots were all produced individually so as to be able to print the logo face down and get the best quality from the print with an inlay of the logo rather than a separate stick on plate, this is only then a 7 filament change design rather than having it sit upright with around 71 filament swaps :). I use the pins to hold all the pieces together and cut some M3 bolts heads for the holes in the outer sides for aesthetics. Also, the Logo is the correct orientation in this model unlike others where they are technically upside down

See my other posts for other Disk designs ;)

Please don't forget to rate this :)