Swiss Army Key Holder
Swiss Army Key Holder
Boost
9
19
1
Print Profile(3)
original height - 0.16mm layer, 2 walls, 25% infill
54 min
1 plate
less z height (4mm) 0.16mm layer, 2 walls, 25% infill
39 min
1 plate
less z height (4mm), two-color, 0.16mm layer, 2 walls, 25% infill
40 min
1 plate
Boost
9
19
1
0
14
4
Released
Description
Summary
Swiss Army style keyring.
Remixed from Mark Bensons V2 with thumbnail cutouts.
Changes: thumbnail cutouts elongated slightly, keyring hole reinforced through expanded size and ribbing, and corners chamfered instead of rounded.
Still uses M3 bolts, washers and nuts to assemble.
Print Settings
Printer:
Wanhao Duplicator i3 / Cocoon Create
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.20 - 0.25
Infill:
Doesn't Matter
Instructions
Place keys with an M3 washer in between each. Don't over tighten or keys wont move. Don't over tighten centre bolt or sides could snap.
Comment & Rating (1)
All
Great model, thanks!
Created some print profiles, hope you're fine with that. :)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld