This is version 2 of my poop chute. Version 1 is here : https://makerworld.com/en/models/142243
This version is half the width so it doesn't stick out as much from the back of the printer and I have strengthened the screw hole as the original could break off if you slide in your poop bucket and knock the chute.
The reason for this chute is that the machine would poop and it would catch the lip of my poop bucket and still end up on the floor. I designed this little deflector to ensure the poop was redirected into the bucket every time. It's deliberately designed slightly short of the height that most poop buckets are made so that removal of the poop bucket doesn't get tangled on the bottom of the deflector. The screw hole is designed to be very tight and self threading to keep the deflector in place. You can use the pre-installed M3 8mm bolt from the printer directly above the chute to mount it - or any M3 8mm bolt or screw will probably work as well if your printers bolt is shorter or not present.
PRINT INFO:
Profile : 0.20mm Standard
Material : PLA
Brim : Yes
Filament Used : ~19g
Print Time : ~42 min
No Infill
3 wall Loops