Galaxys Edge power outlet plate small
Boost
81
114
8
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
3 Colors Pre-Painted - 0.2mm layer, 2 walls, 15% infill
8.4 h
2 plates
Open in Bambu Studio
Boost
81
114
8
4
131
44
Released
Description
Galaxys Edge Panel Power outlet Cover
This can be printed using a single-color PLA
Print Settings
0.2mm layer
2 walls
15% infill
Ironing on top surfaces for a smooth finish
supports required for the bottom section of the plate, no raft, or skirt is needed.
For best results use Ironing on all top surfaces
Comment & Rating (8)
All
Absolutely awesome!!! Printed fantastic on Ender 3 S1.
The designer has replied
1
Reply
thank you so much
0
Reply
Boosted
Love these models.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Recently painted my theater black and added these plates to achieve the aesthetic I'm going for. They look absolutely fantastic. I painted them in Bambu Studio with some minor variations between plates. Less than 15g waste between purge and tower, but I put the purge into some fidgets I was making anyway so total waste was under 2.5g.
First plate was about half a millimeter too thick so I cut .5mm off the bottom and reprinted the rest so I wouldn't need to use spacers.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
words perfectly!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fixed a broken outlet cover in my house by replacing it with this. looks great, and it's fun too.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld