Fidget Keychain Spinner print in place
Boost
9
7
6
GIF
Print Profile(1)
0.12mm layer, 2 walls, 50% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
9
7
6
0
28
18
Released
Description
Print in place keychain spinner. The print is very fast end use very low filament. Print it with 0.12mm layers, I don't think 0.2mm will be enough for spinning. The bearing has some space around it, maybe it could be scaled to 1.01/1.02. Enjoy spinning and share your prints :)
Comment & Rating (6)
All
Print Profile
0.12mm layer, 2 walls, 50% infill
simple and nice
The designer has replied
1
Reply
Thanks😄 Did you find the bearing a little loose? I am thinking to try and scale it up by a very small percentage so it can fit better
0
Reply
Yes it is a bit loose. But not that bad. If you do a remake I will print it too 😎
0
Reply
Replying to @hollowmaker
I'll try to make it fit better, probably I'll try later or tomorrow, btw thank you for the feedback😄
(Edited)1
Reply
Print Profile
0.12mm layer, 2 walls, 50% infill
super
The designer has replied
0
Reply
😄
(Edited)1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld