Glock Water Gun - Barrel Extension
Copyright Claim
Glock Water Gun - Barrel Extension
Boost
2
5
3
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
39 min
1 plate
Open in Bambu Studio
Boost
2
5
3
0
31
4
Released
Description
Because of the ugly Barrelfinish of this Water Gun and to protect the small tip from getting damaged to soon, I've decided to add this “missing piece”. It fits without any Glue or Screw, just by friction. Unfortunately I was running out of orange PLA, so I used black instead ;-)
Comment & Rating (3)
All
Greetings from China, how much did you spend on this? Just curious
The designer has replied
0
Reply
Just found your Question, so sorry for the late answer. I'm not sure if I get your point here, but anyway: I just needed a few Minutes for the Design and two times changed the Size. Overall and including the Print, just about an hour of work till the finished Product...
0
Reply
Replying to @GigaGremlin.
I'm curious how much money you spent on this toy. I have a same one.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld