LED Strip profile 45 degree by UlleiJ

UlleiJ

Hobby & DIY>Electronics

Print Profile(4)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.28mm layer, 2 walls, 5% infill

Designer

1.7 h

2 plates

4.9(25)

0.28mm layer, 2 walls, 5% infill

Designer

6.4 h

2 plates

5.0(1)

0.2mm layer, 2 walls, 15% infill

3.9 h

2 plates

5.0(1)

0.16mm layer, 4 walls, 15% infill

23 min

1 plate

Boost

407

735

551

418

Released

Description

I have designed this profile for LED strips up to max 15mm wide. The beam angle is 45 degrees, making this profile perfect for indirect lighting. The fit is perfect and the diffuser snaps into place on the side without the need to use glue.

Printed in PLA/PETG translucent
0.28mm layer height
2 walls
scale lengthwise as needed to fit your printer bed

Update 29.02.2024

New: endcap with hole
New: connectors for LED profiles

Update 28.02.2024

New: endcap

Comment & Rating (41)

@savolab

Print Profile

0.28mm layer, 2 walls, 5% infill

very well designed

The designer has replied

@UlleiJ

Thank you 🙏

@Mike770502

Print Profile

0.28mm layer, 2 walls, 5% infill

printed in boack and white pla

@smith6nl

Print Profile

0.28mm layer, 2 walls, 5% infill

they printed very clean! now I just need to make an end cap for them.

The designer has replied

@UlleiJ

Have a look at the raw files 😀 Endcaps are available. Thanls for your rating 🙏

@Diggle

Print Profile

0.28mm layer, 2 walls, 5% infill

strong design, clean print

@aschi2584

Print Profile

0.28mm layer, 2 walls, 5% infill

End caps for this would be nice, otherwise great.

The designer has replied

@UlleiJ

Many thanks for your review! Good idea with the end caps. End caps are now available :-)

(Edited)

@uomobarba

Replying to @UlleiJ :

and also a small connector to joint togheter the bars :)

@aschi2584

Replying to @UlleiJ :

Perfect fit and cutout installed using the slicer itself. Thanks for the add. good job

@user_3822245831

Print Profile

0.28mm layer, 2 walls, 5% infill

i absolutely love this print I almost wish you had adaptors to chain them together. I used glow in the dark white filamefor the defuser and I love it. works great while lit up can’t even tell it’s glow n the dark until you turn off the lights. very cool

The designer has replied

@UlleiJ

Have a look at the raw files. There are connectors available 😉 Thanks for your rating 🙏

(Edited)

@user_3822245831

Replying to @UlleiJ :

you’re awesome my guy lol I’m a print these with my Neptune max now and go full scale in length ☺️

@vosaism

Great model! The only issue I had is that the description says that this is made for LED strips up to 15mm wide, but the Philips Hue lightstrip for which I printed this measured ~14.5mm in width and the part was too small, measuring at about 12.5mm. I scaled it up about 115% and that fixed the problem.