Just a fun 3 piece drink holder print for sta paddys day to hold your drinks in.
Print settings:
.20 standard with arachne walls
Strength 8% gyroid with ""infill combination" (checked) and internal solid infill pattern set to rectilinear, top surface concentric (most of this will probably not matter as the print has minimal infil areas)
Tree(auto)> Tree Organic, build plate only and remove small overhangs (checked)
Auto Brim worked for the buckle
Easy assembly:
1. print hat, print black band, print buckle.
2. put a few small dabs of glue on the buckle sides and then center it and stick it to the black band
3. slide the band over the hat and optionaly glue it if desired
should fit most 12oz cans
Attached the “st p hat complete” stl in case you want to try multicolor but i havent tested yet.. will upload a final version single color to be painted option, but if you try it your feedback is welcome!