Rotating Table (Lazy Susan)
Boost
56
98
24
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
3.1 h
1 plate
0.2 layer, 3 walls, 100% Infill
Designer
5.1 h
1 plate
Boost
56
98
24
2
245
154
Released
Description
Rotating Table (Lazy Susan) 200mm table surface
I needed a rotating table for painting purposes so i designed this one up quick myself. Its currently setup for a 6000rs or 6000z bearing but all the parameters can be adjusted in Bambu Studio through the objects tab. Can also be used as a cake stand or display stand
Update 10/03/2023: Wrong bearing size was posted so i've since changed it to the correct one.
Parts Required:
6000rs or 6000z bearing
Bearing Dimensions: 10mm x 26mm x 8mm (Inner x Outer x Width)
Comment & Rating (24)
All
a 6008 bearing is 40mm ID. 68mm OD. it does not fit this. which bearing is it for?
The designer has replied
0
Reply
You are correct, I made a mistake. Its supposed to be a 6000rs or 6000z. I will change it, sorry for the mistake. I must have mixed up which bearing went with this and another with a different print i did.
(Edited)0
Reply
Replying to @MrTingles
Thanks for the response and no problem, we all make mistake it is called being human. Thanks for the design
1
Reply
Do you know if there is a printable bearing for this? I only have 608. Thanks.
The designer has replied
0
Reply
There is many printable 6000 series bearings. Go to Thangs website and search for a 6000 bearing and many will show up!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Not very well balanced but printed well
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Perfect for a small display
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
It printed just fine but the Lazy Susan is not good for heavier parts.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
:)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Nice work!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Came out great. thanks
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
clean, run on standard, bumped to sport and infill was getting messy, set back to standard and finished good
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld