NOTE: Will lose some Z-height with this.

Made a slightly longer cable holder/strain relief to go on my sprite extruder, since it was really kinking the ribbon at the bottom just in by the connector, and it seemed rather flimsy so I wanted to grab onto the ribbon cable higher up where there was more reinforcement.

Probably not a big deal, I just really dislike looking at cables being kinked that hard.

I've only made sure this works with clearances for the vertical arms on the Ender-3 S1 Pro since that's what I have. Make sure it doesn't interfere with your X-axis when it's going for the homing limit-switch if you have a different printer.

I printed it in PCTG with no supports.