Simple fidget cube that can be 100% 3D printed. No extra stuff needed - and the assembly is easy.
Although I haven't tried, scaling should be perfectly viable - just don't make it any smaller as the resistance for the switches will become too fragile. Scaling up should be easy - I chose this size because I have relative small hands.
If you wish to donate, feel free to do so at: https://paypal.me/jakobdam
Rafts:
Yes
Supports:
Yes
Resolution:
0.1 (0.2 or 0.4mm nozzle)
Infill:
25%
Filament: Polymaker Polyflex PLA Black
Notes:
This is an easy print; print with the following settings:
0.1mm layer height (for increased precision)
3 walls (just the right amount of sturdy)
15% infill (that's quite enough)
Print with support (in Cura, I usually choose Tree support)
Print on raft (for better bed adhesion for the parts)
On my Monoprice Delta Pro, I can run this print at 80 mm/s and thus get a print time of around 2 hours and 30 minutes for the "ASSEMBLED" file which prints all components at once.
Demo of the JD Fidget Cube v1