Search models, users, collections, and posts
Stronger Microphone Stand w/ Samson Meteor adapter
Remixed by
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
6.2 h
1 plate
0.2mm layer, 2 walls, 15% infill
6.1 h
1 plate
0.2mm layer, 2 walls, 15% infill
6.5 h
6 plates
Open in Bambu Studio
Boost
91
213
9
3
359
165
Released
Description
A remix from the - already great - Microphone Stand from STLsupplier. Check out his models!
Update 01/06/2026: the screw holding the clamp and arms together is now also printed flat.
The arm screws are now modified to be printed flat, and the risk of them snapping is now very limited.
I did not modify the clamp screw as it does not require as much force to properly stay in place. As a general rule, do not tighten (at all!) screws that are printed upright!
And as I was printing this for a Samson Meteor microphone, I included my adapter for this model of microphone.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (9)