Hex Container for Printdry Pro Desiccants Packets
Copyright Claim
Hex Container for Printdry Pro Desiccants Packets
Boost
1
2
2
Print Profile(1)
PETG - 0.2mm layer, 3 walls, 10% infill
Designer
18.2 h
2 plates
Open in Bambu Studio
Boost
1
2
2
0
9
2
Released
Description
The desiccant container inside the PrintDry Pro was a little small and limiting so I made a taller and wider one. It sits right in between 2 spools. You may have to scale/cut it down to fit yours if you don't have the extra chamber on top. PETG/ABS/PC/PA is recommended.
I recently added a new version with a couple of holes to make grabbing it easier.
Comment & Rating (2)
All
Print Profile
PETG - 0.2mm layer, 3 walls, 10% infill
printed great
0
Reply
Print Profile
PETG - 0.2mm layer, 3 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld