Rugged Apple Air Tag Case
Copyright Claim
Rugged Apple Air Tag Case
Boost
15
28
10
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
40 min
1 plate
Magnetic Version
Designer
42 min
1 plate
Boost
15
28
10
1
65
71
Released
Description
Rugged air tag case for protection. allows the signal out and prevents damage. Also disguises the tag. Add a 3m mounting tape to mount in even more locations!
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Good sturdy print but I needed to file down the threads as it wouldn’t screw completely down. Once that was all done, airtag fitted nicely!
The designer has replied
0
Reply
Thank you for the feedback! I will look into increasing the tolerance a bit more and adding an additional profile (came out smooth on my end but every filament/printer is different). Thanks again!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
the threads did not turn out good. can’t screw them together the whole way
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works great. thank you
The designer has replied
0
Reply
thank you for your review!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect fit.
0
Reply
Print Profile
Magnetic Version
Print turned out great! Thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:Printed on P1S, strenght profile, I could not screw the cap on :/
1
Reply
Print Profile
Magnetic Version
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:Unfortunately, while the print looked nice, the threads didn't print well and even after trying to clean that up I could never get it close completely. Might need to improve the threads and/or tolerances.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld