Ghost from Call of Duty Modern Warfare/Warzone figure/statue (1/10)

Copyright Claim

Ghost from Call of Duty Modern Warfare/Warzone figure/statue (1/10)

Boost
181
207
28

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.12mm layer, 2 walls, 15% infill
0.12mm layer, 2 walls, 15% infill
Designer
10.7 h
1 plate
4.5(19)

Boost
181
207
28
8
456
114
Released

Description

If you like this model please make sure to like it and post a make if possible :) Happy printing

Comment & Rating (28)

Please fill in your opinion
(0/5000)

Print Profile
0.12mm layer, 2 walls, 15% infill
Awesome print, it's difficult to remove supports when smaller than 50% original size
The designer has replied
1
Reply
smol ghost :)
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Endorsements are hard to remove, but the model is great.
(Edited)
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
amazing print!!! great details. supports were a bit of a nightmare to remove but they left no damage. Just need to sand a few bits and paint it now.
(Edited)
0
Reply
Awesome print, I printed it for a friend who loves Ghost. But i did manage to break some parts because its very hard to remove the supports. But she told me to not print it again because she liked it anyways with all the imperfections. Here is it after applying some colors
0
Reply
可以
0
Reply
very good model, I prefer printing this
2
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
I gave it 5 stars because it printed just like you said. I need tips on removing supports. I broke the magazine on the rifle hes holding as well as what looked like a wire from the walkie talkie box in his front left chest pocket to his in ear. Absolutely my fault. I am very new to printing. Any tips you have for support removal would be great.
The designer has replied
0
Reply
Hey, Thank you for the rating. you need to be veeery careful while removing them, Maybe try to make your own print settings that might remedy the issues. Im Also planning to work on an updated model that is split into parts and allows to reprinting of certain parts and printing them in finer details
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Very detailed print. Be careful removing the supports around the rifle.
(Edited)
1
Reply
thought it was resin first :)
1
Reply
Can this be enlarged to the point where only the head is used to make a headphone stand
0
Reply