Large Poop Chute
Copyright Claim
Large Poop Chute
Boost
4
5
4
Print Profile(1)
0.28mm layer, 1 walls, 15% infill
Designer
5.5 h
2 plates
Boost
4
5
4
0
21
7
Released
Description
NOTE:
This only works if you are using a 16x16x1.88 paver stone, I have just included a version that is taller and has a sperate back splash that needs to be glued on however I have not printed it to test.
Was looking for that fit my needs decided to design my own
Printing Instructions:
I used the standard 0.20mm Bambu Profile
No Brim
No Supports
4 walls
6 Top / Bottom
Takes a little over 6 hrs on standard speed
Comment & Rating (4)
All
does not fit for p1s
The designer has replied
0
Reply
would you mind snapping a photo of how you have it setup? I don't have a P1 series but was under the assumption that both the X1 and P1 series were Identical.
It should just slide behind the printer, you align thee flap with the actual hole in the back of the printer, and the lip should also close the cap between between the printer and the bin.
0
Reply
it also maybe the fact that when I designed this it was taking into account the printer sitting on a paver stone
0
Reply
The print profile is no longer public
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld