Xbox elite controller charging stand
Xbox elite controller charging stand
Boost
68
90
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.8 h
3 plates
Boost
68
90
10
2
108
65
Released
Description
2 20 x 3 circle magnets are needed for the base of the stand.
I also use rubber feet from amazon for the feet to stop it from sliding about
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed perfectly!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld