Counter Cleaner Remix: Under Counter Bin Remixed by Catsmgee

Remixed by

Catsmgee

Household>Other House Models

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

"Wide" 0.2mm layer, 2 walls, 10% infill

Designer

4.2 h

1 plate

5.0(8)

0.2mm layer, 2 walls, 10% infill

Designer

4.4 h

1 plate

4.4(5)

With Brims to avoid the lips lifting

3.9 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

114

Released

Description

A remix of Cookiedeluxe's Counter Cleaner, designed to slot past the edge of the counter so that no crumbs/debris fall between the cleaner and the counter.

There are two versions, a “standard” opening of about an inch, and a “wide” version that is twice as wide (about 2").

Original model found here: https://makerworld.com/en/models/188957#profileId-212942

“This Counter Cleaner helps you to easily, quickly and thoroughly clean things off your kitchen counter / dining table / office desk. Just place it against the counter or table, sweep everything into it and you're done!”

Comment & Rating (18)

@Isew68

Boosted

Print Profile

"Wide" 0.2mm layer, 2 walls, 10% infill

I like the design. I tried printing this remix and the original at least four times. I tried it with glue/without gllue and with a brim/without a brim. I finally got it to print right with glue and an inside/outside brim. After all that it did not clean up right and has rough edges. I may try it again.

(Edited)

@Makanize

Boosted

I had to add a brim and make sure the Aux fan is off for at least until we get 1/3 way up the print. There is no way to turn off the Aux fan in the print profile so far I know (It can be done from Filament setting and manually while printing) but added a print profile with Brim for the wide model. Have printed 10+ of them so far with no issues after that. It is a very popular gift at my mom's book club :). Thanks OP and the remixer.

@Isew68

Boosted

Replying to @Makanize :

Thanks for the help. I followed your suggestion with the aux fan and made a couple other little changes. I got a great print.

@SRQMaker

Boosted

Print Profile

"Wide" 0.2mm layer, 2 walls, 10% infill

Printed well. Very useful in the kitchen.

@user_3478299689

Print Profile

With Brims to avoid the lips lifting

correct

The designer has replied

@Makanize

Boosted

Hoping the original designer can clarify but I think that’s part of the design so the lips can be removed easily if someone doesn’t like it. Please keep in mind you’ve added the rating to the print profile not thr model. Is there anything wrong with the print profile?