Hi guys, this is my first posting/sharing hope you will bare with the result or some error it mights contain.

Please comment to make some correction if needed.

(Result was nice on my printing, see pictures, so hopefully file is ok)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Swap Instructions:
Start with Black
At layer #30 (2.48mm) swap to Red
At layer #34 (2.8mm) swap to Gray
At layer #39 (3.2mm) swap to White for the rest.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Swap Instructions:
Start with Black
At layer #30 (2.48mm) swap to Red
At layer #34 (2.8mm) swap to Gray
At layer #39 (3.2mm) swap to Jade White for the rest.